Nema 23 1.5Nm High torque Stepper Motor 1.8 Deg, Single shaft

DataSheet: 57HS64-3008 1.5Nm Stepper Motor
DataSheet: CW5045 microstepping Driver
DataSheet: CW5045 Wiring Diagram
DataSheet: CW8060 Wiring Diagram

High holding torque of 1.5Nm with is equivelant to 212 oz-in.
These motors are superb for upgrading your equipment to CNC due to there high torque and Nema 23 low profile, High Torque with low profile compared to Nema34 allows for lower start up inertia and normally better speed and acceleration due to less mass to spin.
Eight wire design allows for Bipolar Parallel and series connection, also compatible with unipolar drivers. Can easily be paired with our 4.5 Amp Advanced microstepping driver CW5045 which has an amazing power output and switching capability.
Don't compromise your design higher torque with good quality controller gives better resolution accuracy when using Microstepping.