Nema 23 3 Axis Control 

This unit is suitable for our Nema23 stepper motors from 1.5Nm to our 4.5Nm or your own steppers please check for compatibility if in doubt as no steppers are supplied with this unit please see other controller's as full kits.


This Kit contains the following matched parts for your CNC project. Pictures are for guidance only please check product info below as individual components may vary.

These controller have multiple inputs and outputs see documentation and can be set to your current and microstep settings on request.

1 x 4 Axis Breakout Board with 0-10V Output
4 x Microstepping Drivers 1.4A to 5.6Amps Output Current
1 x 480Watt or 600Watt PSU 48Volts
1 x NVR Switch

1 x 24V PSU

1 x Panel Mount Filter 10A
1 x UC400ETH Motion Controller
Panel Plug connectors for rear panel sockets.

DataSheet: 4 Axis Pinout Wiring Diagram
DataSheet: Breakout Board CP0-10V

Please let us know if you require us to set drivers to match your stepper motor requirements normally allow an extra day for custom configuration. Please see our other control units with prewired steppers or contact us with your requirements.

Write a review

Please login or register to review

Control Box 4 Axis N23

  • Product Code: Control-Box-4-Axis-N23
  • Availability: In Stock
  • £847.80