Replaced with CP0-10V
5 axis breakout board Mach3, Mach4 HG08
1. Connection for 5 driver boards to control 5 stepper motors or other output devices needing step and direction signal or use to control as standard isolated output 11 lines available to control.
2. Input from computer parallel port signal are cleaned and noise reduced using onboard logic chips.
3. Support Mach3, Mach4 and EMC2.
4. Uses 6N137 very high speed 10 Mbits/sec logic gate optoisolators
5. 5 wire limit switch or general input port pins to ensure the machine safety and monitoring.
6. Onboard relay port can control vacuum table etc.
7. With full optical isolation and DC/DC power supply isolation giving a minimum of 1000 Volts isolation to enhance protection of your computer parallel port and equipment.
8.Recommended power supply from 9V to 24VDC use filtering for PSU in noisy enviroments.
Supplementary technical data:
•1 x 5 Axis Interface Breakout Board HG08 (WARNING THIS IS NOT A STEPPER DRIVER BOARD)
Breakout board CNC Stepper Motor 5 Axis Relay HG08
- Product Code: HG08
- Availability: Out Of Stock