5 axis breakout board MACH KCAM4 EMC2 driver interface adapter HG08
Version change to allow driving of some new generation drivers. Operationally the same as HG08
1. Connection for 5 driver boards to control 5 stepper motors or other output devices needing step and direction signal or use to control as standard isolated output 11 lines available to control.
2. Input from computer parallel port signal are cleaned and noise reduced using onboard logic chips.
3. Support MACH3,EMC2,KCAM4 and NcStudio control software
4. Uses 6N137 very high speed 10 Mbits/sec logic gate optoisolators
5. 5 wire limit switch or general input port pins to ensure the machine safety and monitoring.
6. Onboard relay port can control vacuum table etc.
7. With full optical isolation and DC/DC power supply isolation giving a minimum of 1000 Volts isolation protection, and 100mAmp outut drive current from provided VCC output, to enhance protection of your computer parallel port and equipment
8. Wide Input power supply from 7V to 55V makes it compatible with our product range and easy connection interface from our PSU in industrial, noisy or plasma environments use filtering and separate PSU.
9. Easy screw connection with plug and socket for easy assembly and testing.
Supplementary technical data:
•1 x 5 Axis Interface Breakout Board HG07 (WARNING THIS IS NOT A STEPPER DRIVER BOARD)
Breakout board CNC Stepper Motor 5 Axis Relay HG08
- Product Code: HG08
- Availability: In Stock